Evolution-engines EVOE33GX Bedienungsanleitung

33ccEvolution® Gas EnginesGAS/PETROL

EN10Engine Break-inYour new engine needs to be broken-in to ensure a long life of all the components. This engine features a piston ring design, which

EN11Baseline needle valve settings can be found in the ”Engine Tuning” section. With the 33GX it is very important to allow the temperature to stabili

EN12The break-in settings for the carburetor needles are: • High-speed needle: 1.5 turns open • Low-speed needle: 1.5 turns openUse a tachometer (HA

EN13Once the engine is running reliably at full (open) throttle:1. Turn the high-speed needle clockwise 1/16 of a turn at a time.2. Wait 2–3 seconds

EN1433GX Evolution Engines SpecicationsDisp Bore (mm) Stroke (mm) Weight (oz) Cylinder Propeller33cc 37.5 29.5 48.8 Ringed 18 x 8 @ 8300 rpmAC DFHG70

EN15Exploded View223 22 2024134/2956783126/291211102128/29/3028181529191716 14252732913

EN16Parts List# Description Part1 Engine Crankcase Screw Set (10)EVOG33464082 Spark Plug (CM6) EVOG333503 Cylinder Head EVOG331034 Cylinder Head Gaske

EN17Limitation of Liability - HORIZON SHALL NOT BE LIABLE FOR SPECIAL, INDIRECT, INCIDENTAL OR CONSEQUENTIAL DAMAGES, LOSS OF PROFITS OR PRODUCTI

EN18WARRANTY AND SERVICE CONTACT INFORMATIONCountry of PurchaseHorizon Hobby Contact Information AddressUnited States of AmericaHorizon Service Center

©2013 Horizon Hobby, Inc.Evolution and the Horizon Hobby logo are registered trademarks of Horizon Hobby, Inc. The Spektrum trademark is used with per

EN2NOTICEAll instructions, warranties and other collateral documents are subject to change at the sole discretion of Horizon Hobby, Inc. For up-to-dat

EN3• Always keep your fuel in a safe place away from sparks, heat or anything that can ignite.• Always ensure the aircraft is secure and will not

EN4IntroductionCongratulations on your purchase of one of the exciting new engines in the Evolution® gas engine series. All of the Evolution brand gas

EN5Throttle ArmRail-mount Installation1. Remove the 4 screws which attach the rear-mount.2. Remove the rear-mount and replace the 4 screws with the sh

EN61. Use a secure method to attach the throttle linkage to the throttle arm on the carburetor.2. Power on the transmitter and receiver.3. Move the

EN7Fuel Line1. Connect medium diameter large diameter FKM fuel tubing to the carburetor and the fuel tank supply line.2. Connect large diameter FKM f

EN8Connecting the Electronic IgnitionThe Evolution Electronic Ignition Assembly is designed and engineered specifically for the small block engine ser

EN9FuelThis engine requires a mix of 20:1 gas to oil lubricant ratio for break-in and a mix of 32:1 gas/oil ratio for normal operation in order to las